Servo Booster Spannung:7.2V for example with heat shrink

for example with heat shrink tubing

Insert the LED cables into the Power Up module

Attach the yellow front LED between the bumper and the Arrma logo by fixing the LED to the bumper holes

Roof LED Extremely bright front LEDs easily mounted under the roof at existing cage holes

Solder the male connector to the LED and secure the wires to the body with tape

Servo Booster Spannung:7.2V for example with heat shrinkThe servo booster was specifically developed for vehicles where the controller receiver only outputs 6V, but the servo is designed for a higher voltage. This is often the case with Traxxas models, for example. It enables faster response speed of servo motors, resulting in noticeably better control and agility of the vehicle. It is simply installed between the receiver and the servo, and converts the existing BEC voltage to 7. 2V or 8. 4V. This is an